How to clean the pipe in the bathroom at home?

A bath in our time is one of the essential conditions for comfort. But even if you use the plumbing as carefully as possible, you still sometimes have to deal with a situation where the water does not go into the drain. You should not look for the guilty one and find out who was the last in the bathroom, you just need to roll up your sleeves and break through the blockage. Today we will tell you how to clean the pipe in the bathroom at home as quickly as possible.

to contents ↑

The main causes of blockages

Before you start cleaning the pipe, you need to make sure that this is not a general, but a local blockage. In cases of clogging of the central sewage system of the house, employees of the housing office are engaged in pipe cleaning.

Important! To make sure that the problem exists only in your apartment, turn on the water in the bathroom and in the kitchen, if in the kitchen the water leaves unhindered, and in the bathroom there is water, then you need to start cleaning the pipes in the bathroom.

The main causes of blockage include the following factors:

• Fatty coating on the pipes. The best way to fix the problem is to use special chemical compounds.
• Design error of the sewer system. The craftsmen could still lay the pipes at the wrong angle when laying the pipes. In this case, the cause of the blockage can be completely eliminated only by correcting the design error and redoing the problem area of ​​the sewer pipe.
• Deterioration of the sewer system.
• Neglect of basic preventive measures and rules for caring for the sewer system.
• Garbage falling into the sink: animal hair, hair, particles of rags, threads, etc.

Important! All these reasons lead not only to the fact that the water ceases to leave normally, but also to the appearance of an unpleasant odor, which is a consequence of the decomposition of garbage stuck in the sink. Therefore, the problem must be solved in any case in order to ensure comfort in the house, especially since you can quickly clean the pipe in the bathroom at home if you know how.

to contents ↑

How to eliminate blockage in the bathroom at home?

If water does not flow well into the drain, urgent measures must be taken to eliminate the blockage. Alternatively, you can use the services of a specialist, but we propose to solve the problem on our own, using one of the methods described below.

Mechanical method

The most common and easiest way that even a woman can use is to clean the blockage in the bathroom with a plunger. This method can even be used as a prophylaxis. The more often you use the plunger, the less often the clogging problem will appear.

Step-by-step instruction:

1. Carefully lubricate the rubber part of the plunger with petroleum jelly so that it fits tightly to the drain.
2. Fill the bathtub with a small amount of water (to the height of half of the device’s rubber bowl).
3. Install the plunger so that the rubber nozzle completely covers the drain hole.
4. With sharp, intense movements, raise and lower the plunger. Air will suddenly fall into the drain and push through the resulting blockage.
5. With the last swing the plunger sharply pull out of the water.
6. Turn on hot water to wash away debris.
7. If the blockage could not be eliminated the first time, repeat the procedure several times.

Important! You can also use a vacuum cleaner to remove the problem, if it has the function of reverse blowing air and is very powerful. Proceed as follows:

• Cut the rubber ball in half so that one half is smaller than the second. The size of the ball must be larger than the drain hole.
• Fold the halves into each other, and in the middle make a hole equal to the diameter of the pipe of the vacuum cleaner.
• Insert the vacuum cleaner pipe into the hole and secure the structure with electrical tape or clamps.
• Connect the hose to the outlet of the vacuum cleaner.
• Pressing the homemade plunger, turn on the device. The cleaning process can be compared with the operation of the plunger, with the addition of a powerful air stream.

How to break a blockage in a bathroom with a sanitary cable?

Of course, with the help of a plunger, only small blockages can be removed. For more serious problems, if the blockage is far away in the pipe or the lump of garbage is strongly compressed, it is possible to clean the pipe in the bathroom at home only with the help of a plumbing cable.

The essence of this method is as follows: with the help of a cable, garbage is pulled out or pushed into a wider highway.

Important! A plumbing cable cannot be used to clean plastic and chrome pipes, as their inner surface can be damaged.

This procedure is carried out as follows:

1. Put gloves on your hands.
2. Disassemble the siphon under the sink.
3. Extend the end of the cable carefully so that it can catch the debris.
4. Insert the straightened end into the drain hole.
5. Gently rotate the debris along the pipe with gentle rotational movements.
6. After the main obstacle is removed, make a few sharp jolts along the pipe.
7. Pull the cable along with dirt.
8. Pour hot water into the drain hole.

Important! To make it convenient for you to clean the pipe in the bathroom at home, take note of the following nuances:

• A plumbing cable can be purchased at the store, or you can make it yourself: take a piece of a sufficiently flexible metal cable, bend the end and fluff the tip. The cable will move well along the bends of the pipe and will not be able to rest against the knee. For ease of use and grabbing the cable, wrap it with something rigid to make a kind of handle.
• For efficiency and convenience, work together with a cable. The assistant will monitor the cable tension. Push the sharp tip into the drain hole, and at the same time the assistant will carry out rotational movements. Turn on the water and continue to act as a cable, water and the movement of the cable inside the pipe will cope with the blockage.

Using a tight hose:

1. Put a rubber tight hose on the hot water tap and tighten it securely.
2. Immerse the other end of the hose in the drain hole as deep as possible.
3. Turn on the water.
4. Move forward with a hose.
5. The pressure of hot water and pushing movements will affect the blockage and remove it.
6. Fill a full bath of hot water and abruptly open the drain cover. Work as a plunger at the same time so that the water, due to pressure, rinses off the remaining clogging.

Siphon cleaning

The siphon must be cleaned not only during blockage, but also with the aim of preventive measures to get rid of the unpleasant odor.

Proceed as follows:

1. Lay a soft cloth on the floor under the siphon.
2. Place a basin or bowl.
3. Carefully unscrew the fasteners.
4. Remove the flask.
5. Wait for all the water to drain into the prepared container.
6. Clean the siphon from debris.
7. Rinse the siphon with running water.
8. Replace the device. Pay attention that the drain pipe does not rest on the flask, otherwise the water seal may break.
9. Without removing the pelvis, turn on the water and make sure that the tightness is not broken.

to contents ↑

Chemicals are faithful helpers

To clean a blockage in the bathroom at home is possible without plunger, plumbing cable, and using modern cleaning products.Today, there are a large number of chemicals on sale that can clean sewer pipes. Some contain acids, others alkalis. But it is necessary to approach the choice of drugs with all responsibility and compliance with safety rules.

Important! A good tool will clean the blockage in the bathroom in minutes and without any effort. Chemicals are especially effective in managing operational blockages that are organic in origin.

Types of drugs for blockages

Preparations are available in various forms:

• Powders.
• Gels.
• Liquids.
• Special foams.
• Granular preparations.

Popular pipe cleaners:

• "Mole" is an effective tool, but it can not be used for plastic pipes.
• “Mr. Muscle” - suitable for all types of pipes. Available in the form of gel and foam. Cleans pipes from dirt, kills bacteria and helps eliminate odors.
• “Pothan” - quickly and completely dissolves various pollution. It has a pungent odor, but breaks through the strongest blockages. This is an Israeli product that needs to be filled in portions of 100 grams. This amount is enough to instantly fix the problem. The main disadvantage is the high price.
• “Tiret” - perfectly copes with its task, eliminates the blockage quickly and effectively. No odor of ammonia.

Mode of application

To break a blockage in the bathroom, these funds must be used according to the instructions:

1. Pour or pour the product into the sewer hole.
2. Leave for a while.
3. Rinse thoroughly with running water.

Important! Use chemicals properly, since even the safest drugs with long-term use will deform the pipe material. When using blockage cleaners, always remember the safety precautions: wear rubber gloves, special clothing and safety glasses. In the bathroom, a constant movement of air must be created so as not to breathe in harmful fumes.

Helpful hints:

1. When choosing a chemical product directly to remove blockage in the bathroom, opt for a product that can dissolve hair. When choosing a kitchen product - for products that can dissolve fat.
2. For plastic pipes, use gel or granular chemicals (the latter is preferred).
3. When buying household chemicals, pay attention to the purpose of the funds. They are of two types:
   • preventive - can cope with a slight blockage;
   • more powerful, able to work even in still water.

Recent preparations are necessary when the drain hole is completely blocked.

to contents ↑

Folk remedies for blockages

Previously, every housewife knew how to clean the sewer with soda and vinegar. Today, the use of folk remedies is increasingly less frequent. Nevertheless, using tools at hand is very simple:

1. Take soda and vinegar in an equal amount (one glass is enough).
2. First, pour soda into the drain hole, and then pour the vinegar.
3. Close the drain plug.
4. Leave the ingredients for a chemical reaction for 2-3 hours.
5. Rinse the drain with boiling water.

Important! The use of soda is one of the safest and most effective ways. Soda perfectly removes clogging and does not harm the internal surfaces of pipes. Use soda for clogging and for prevention.

Other home remedies options:

1. Use lemon to remove body fat. Squeeze a few fresh lemons in the drain hole and leave for an hour. Fresh lemons can be replaced with lemon juice concentrate.
2. If you do not want to use modern products, then prepare a cleanser from improvised products. You will need: a glass of salt, a glass of soda, ¼ glass of tartar (crystallized precipitate during the production of wine). Stir the ingredients and put in a clean jar. Close tightly with a lid.If necessary, use the prepared product as follows: ¼ Pour the contents of the can into the drain hole, and pour 300 ml of boiling water on top. After a minute, turn on cold water and rinse off the rest of the product. Perform a cleaning procedure for prevention weekly.

to contents ↑

Blockage prevention

If regular preventive measures are taken, then many problems can be avoided.

As measures to prevent the occurrence of blockages, do the following:

1. Install a fine mesh on the drain hole to catch debris.
2. Use a plunger periodically to prevent clogging.
3. Use household chemicals to clean the pipes, pouring it periodically into the drain (once in 2-3 months).
4. Try not to bathe the animals in the bathroom.

to contents ↑

Stock footage

Eliminate the blockage immediately after it is detected so that accumulated additional debris does not complicate the procedure. And in order to remember problems as little as possible, take preventive measures at least once a month and, of course, collect all the garbage before it gets into the drain of the bathtub or sink.